Brands CHARGERY
Product Code: DCC-300HB
Availability: In Stock
$89.90
Ex Tax: $89.90

Available Options

The DC contactor is designed special work with CHARGERY BMS’, the following are some features: 

  • Bi-directional connection, one DCC can be used in a Common port such as a Solar system, instead of two SSR's  (Solid State Relays) or conventional relays.  
  • The DCC has a Built-in the surge suppressing circuit, thereby eliminating the need for the additional Relay Delay Time board which is used to avoid a surge current when starting to charge or discharge. For other SSR's or mechanical relay, please consider the surge current potentials seriously and make a suitable plan for using a delay board as applicable. 
  • Over temperature protection. If internal temperatures over heat, the contactor will shut off. 
  • One  Intelligent cooling fans turned on automatically  
  • Approved by CE 
  • 12 months warranty 

Specifications




Installation

CHARGERY DCC should be installed on the battery negative. It has the following advantage: 

  • Lower holding current (under 11mA for 600A DC Contactor), save more battery energy. 
  • Bi-directional allows it to be used in common port and separate port configurations. 
  • Nothing extra is needed to have both charge and discharge control signals to control one DCC in common port application. 
  • The Relay Delay Time Board Even is not needed to avoid surge current, as it is built-in. 

 

Compare with SSR (Solid State Relay), the Chargery DCC is bi-directional and can handle up to 600A current at 100V DC.  ONE Chargery bi-directional DCC can be used in common port, and receive both HV and LV cut off signal. If not using the Chargery DCC, you would require two SSR's or two relays, which would increase power consumption and have a higher cost. 


Manual


Package

  • DCC base unit: 1pcs 
  • Connection wire: 1pcs 
  • Lugs: 2 pcs 
  • Screws: 2 pcs 
  • Washer: 4pcs



Write a review

Note: HTML is not translated!